TechnicianVision · Knowledge base
Something To Watch For When Replacing Blind Spot Sensors
I-CAR · May 30, 2019
Summary
This article highlights a common installation error where self-calibrating blind spot detection sensors are mounted backwards or incorrectly due to physical mounting designs that allow multiple orientations. Even though these sensors self-calibrate, they will fail to function properly if they are not installed in the correct physical direction.
What to do on the job
Visually verify the correct physical orientation and mounting direction of blind spot sensors during installation, as some brackets allow them to be mounted backwards.
How to use it
Use this document to justify the labor time required for meticulous visual inspection and verification of ADAS sensor orientation during assembly, proving that self-calibration features do not eliminate the need for precise physical installation.
This page is a summary written by TechnicianVision. The document itself belongs to its publisher — follow the link above to read it in full.
TechnicianVision puts procedures like this next to the repair order you are working on. Create a free account →