TechnicianVision · Knowledge base
Sectioning And Partial Part Replacement: 2018 Land Rover Range Rover Velar
I-CAR · December 14, 2018 · Land Rover
Summary
This article outlines the sectioning and partial part replacement guidelines for the 2018 Land Rover Range Rover Velar, highlighting which structural components can be sectioned or partially replaced and which cannot. It notes that while the front upper rail, rear rail, outer uniside, and trunk floor have approved procedures, the front lower rail, uniside reinforcement, inner uniside, and rear body panel do not.
What to do on the job
Consult the official Land Rover Body Repair Manual (BRM) to locate approved sectioning and partial replacement procedures for the outer uniside, rear rail, front upper rail, and trunk floor, and do not attempt to section the front lower rail, inner uniside, or rear body panel.
How to use it
Use this document to justify the replacement of complete assemblies when dealing with damaged front lower rails, inner unisides, uniside reinforcements, or rear body panels, as Land Rover does not provide approved sectioning procedures for these components. For outer unisides, rear rails, and trunk floors, use this to support the labor and procedures required for partial replacement or sectioning at approved factory seams.
This page is a summary written by TechnicianVision. The document itself belongs to its publisher — follow the link above to read it in full.
TechnicianVision puts procedures like this next to the repair order you are working on. Create a free account →