TechnicianVision · Knowledge base
Sectioning And Partial Part Replacement: 2018 Honda Fit
I-CAR · September 7, 2018 · Honda
Summary
This document outlines the approved sectioning and partial part replacement procedures for the 2018 Honda Fit. It specifies that sectioning is allowed on the front lower rail and outer uniside, while only partial part replacement at factory seams is permitted for the front upper rail, rear rail, and trunk floor.
What to do on the job
Verify specific sectioning and partial replacement locations for the 2018 Honda Fit on Honda's service information website, ensuring no sectioning is attempted on the uniside reinforcement, inner uniside, rear rail, or trunk floor.
How to use it
Use this document to justify the labor and materials required for partial part replacement at factory seams versus sectioning. It serves as a reference to defend why certain structural components, such as the inner uniside or rear rail, must be replaced as a whole or at factory seams rather than sectioned.
This page is a summary written by TechnicianVision. The document itself belongs to its publisher — follow the link above to read it in full.
TechnicianVision puts procedures like this next to the repair order you are working on. Create a free account →