TechnicianVision · Knowledge base
Repairing Blind Spot Sensor Mounting Locations: Honda/Acura
I-CAR · August 29, 2019 · Honda, Acura
Summary
This article highlights that Honda/Acura provides vehicle-specific procedures and measurements for blind spot sensor mounting locations. These measurements are critical for ensuring correct sensor alignment during body panel straightening or quarter panel replacement prior to performing any calibration.
What to do on the job
Measure and verify the blind spot sensor mounting fastener depths and locations using Honda/Acura vehicle-specific procedures before performing sensor calibration or finalizing quarter panel repairs.
How to use it
Use this document to justify the labor time required to measure, inspect, and align blind spot sensor mounting brackets on Honda and Acura vehicles. It proves that verifying mounting location measurements is a required OEM prerequisite before calibration can be successfully performed, especially after quarter panel replacement or rear-end repairs.
This page is a summary written by TechnicianVision. The document itself belongs to its publisher — follow the link above to read it in full.
TechnicianVision puts procedures like this next to the repair order you are working on. Create a free account →