TechnicianVision · Knowledge base
OEM Linking Pin: Subaru Airbag Precautions Clarification
I-CAR · November 29, 2018 · Subaru
Summary
This article clarifies Subaru's service manual precautions regarding the removal of airbag sensors and wiring harnesses during sheet metal work and refinishing. Subaru confirms that these components must be removed to prevent physical or electrical damage if the refinishing process involves spraying paint or clear coat, but removal is not required for minor touch-ups or polishing.
What to do on the job
Remove all airbag sensors and wiring harnesses from the repair area when spraying paint or clear coat, or when performing sheet metal work that could cause shock, deformation, or overspray damage to the components.
How to use it
Use this document to justify the labor time required to remove and install (R&I) airbag sensors, side sensors, and wiring harnesses prior to painting or performing structural/sheet metal repairs on the front or sides of a Subaru vehicle. It provides official OEM clarification that spraying paint or clear coat necessitates complete removal of these SRS components to prevent overspray and electrical damage.
This page is a summary written by TechnicianVision. The document itself belongs to its publisher — follow the link above to read it in full.
TechnicianVision puts procedures like this next to the repair order you are working on. Create a free account →