OEM Linking Pin: Ford/Lincoln Overlap Measurement With Spot Welds

I-CAR · October 30, 2019 · Ford, Lincoln

Summary

This article clarifies Ford/Lincoln's specification for panel overlap width when performing squeeze-type resistance spot welding (STRSW) if the Workshop Manual does not explicitly state a measurement. Ford/Lincoln recommends a typical industry standard of a 50mm wide flange for the overlap.

What to do on the job

Use a 50mm wide flange for panel overlap when performing squeeze-type resistance spot welding on Ford and Lincoln vehicles if the specific workshop manual procedure does not state a measurement.

How to use it

Use this document to justify proper flange preparation and overlap dimensions during structural sectioning or panel replacement on Ford and Lincoln vehicles when the OEM workshop manual lacks specific overlap measurements.

Read the original at I-CAR ↗

This page is a summary written by TechnicianVision. The document itself belongs to its publisher — follow the link above to read it in full.

TechnicianVision puts procedures like this next to the repair order you are working on. Create a free account →